Home | WRX/STi/XT/GT/Baja Turbo | Impreza 2.5 | Legacy/Forester/Baja | Specials | Gallery | Contact Us | Order Form
 

Baja Turbo Performance Stage1 Kit

(Approximately 240 H.P.) Please note, all power outputs stated are only approximations, for reference purposes and will vary depending on each vehicle, its condition, fuel and modifications.

Kit Contains:

  1. Short Ram Intake: Using the same design feature of the velocity stack found on the inlet to the MAF sensor in the factory box this cast aluminum intake carries the velocity stack radius outward to mate up with a 4.5" high flow cone filter.
  2. Downpipe with Cat: Downpipe is a full 3" catted downpipe made from 304 stainless steel. The bellmouth design allows for maximum flow for your Subaru with many mods and / or an aftermarket turbo. The built in high flow catalytic converter keeps it legal while still being efficient.

 

Short Ram

 

Downpipe with Hi-Flow Converter

downpipe

 



NOTE: Under Federal EPA regulation, replacement of original catalytic converters is allowed only if the original converter(s) is missing, or the vehicle has more than 50,000 miles or is at least five years old and the need for a replacement has been established and documented, or a local inspection program has determined the existing converter is in need of replacement. Please note that no aftermarket catalytic converters are legal for installation in California on OBD II vehicles (some 1994 & 1995, and all 1996 and later vehicles). There is a chance of seeing a CE Light: Inefficient cat code when running less than two cats, so if seen, contact us for the mechanical fix (sold separately). All performance parts have been designed and are intended for off highway application only. Installation of these parts on a vehicle intended for use on public roads may violate state or federal laws and regulations including those relating to emissions requirements and motor vehicle safety standards.



'04+ Baja Turbo Stage 1 Kit - complete

$1075.00 + shipping Order Now!

**Note: Please replace the following OEM gaskets when installing the kit: header, uppipe and turbo gaskets. Xcceleration.com highly recommends you install a boost gauge, exhaust gas temperature (EGT) gauge, and air/fuel gauge to monitor your car and ensure safe, reliable performance. Gauges are sold separately



Home | WRX/STi/XT/GT/Baja Turbo | Impreza 2.5 | Legacy/Forester/Baja | Specials | Gallery | Contact Us | Order Form